
Armourtech DPS 101 Concrete Sealer
Moisture mitigation for concrete slabs and walls
Moisture moving through concrete is the cause of lifted flooring, efflorescence, mould, musty rooms and concrete cancer. Armourtech DPS 101 seals the capillaries that moisture travels through and reduces vapour transmission, only allowing concrete to breathe.
Free advice: 021 509 115 or info@nzisl.co.nz
Controlling moisture transmission
Concrete is porous. Water and water vapour move through it from the ground, from the weather side of a wall and from within the slab itself as it continues to cure. That moisture carries dissolved salts to the surface, where it leaves efflorescence, and it lifts adhesives, feeds mould and keeps rooms damp.
DPS 101 creates a permanent chemical fusion inside the concrete that seals the capillaries and channels moisture migrates along. Water vapour transmission is reduced while allowing the concrete to breathe and endure freeze and thaw cycles. The reaction also locks up the free alkali, which stops efflorescence (often called concrete cancer), and it prevents water seepage, vapour migration, condensation, mould, mildew and musty odours.
The treated concrete is denser and harder, so it is less prone to cracking, and because there is no film on the surface it still takes adhesives, paints and coatings normally. That is why DPS 101 is used under floor coverings: it stops the moisture that makes vinyl bubble, carpet smell and coatings flake.
Where moisture control matters most
- Under flooring. Vinyl, carpet, timber and tiles on slabs that still give off moisture.
- Basements and below-ground walls. Seepage, damp smells and efflorescence.
- Concrete block construction. Blocks and mortar are more porous than poured concrete.
- Retaining walls. Permanently wet on one side.
- Coated and painted concrete. Stops the moisture that causes flaking and peeling.
- Healthy homes. Lower moisture through the slab means a drier, healthier living space.
Concrete block and grouting
In block construction the most vulnerable point for moisture ingress is the grout. Unless a non-shrink grout is used, a standard mortar mix shrinks and cracks as it cures, and that gap lets water in. DPS 101 will seal the block and the mortar, but it will not bridge a gap left by shrinkage or a cracked joint. Those need to be filled first, then the wall treated.
Radon and healthy homes
Radon is an invisible, odourless radioactive gas produced as uranium and thorium in the ground break down. It is nine times heavier than air, so it collects in basements and ground-floor rooms, and the warmer, lower-pressure air indoors draws it up through the slab. A typical basement or slab also lets through tens of litres of water and vapour a day.
DPS 101 seals the micro-crevices and pores inside the concrete against water molecules, and against the far smaller radon atoms, so diffusion through the slab and walls stops. Radon is not a widespread problem in New Zealand, but a treated slab deals with it in the same pass that deals with damp.
DPS 101 should be considered part of any concrete project where moisture migration or vapour transmission will matter later. It is far cheaper to treat the slab before the flooring goes down than to lift the flooring after.
Moisture questions
Can DPS 101 fix a damp basement?
It seals the pores and capillaries moisture travels through in the concrete itself, which deals with seepage and vapour through the slab and walls. It does not bridge open cracks, failed joints or shrunk mortar, so those need to be repaired first.
Will flooring adhesive stick after treatment?
Yes. Because there is no surface film, adhesives, paints and coatings bond normally. Treating the slab first is a common way to stop moisture lifting vinyl, carpet or timber.
What about radon?
Radon is a radioactive gas that seeps through concrete from the ground. Sealing the micro-pores against water molecules also blocks the much smaller radon atoms. Radon levels in New Zealand are generally low, but the same treatment covers it.
Related pages
DPS 101 Concrete Sealer
The full product page: what it is, benefits, uses and application.
DPS 101 Concrete SealerGot a damp slab or wall?
Tell us what it is, how old it is and what is going on top of it. We will tell you whether DPS 101 will fix it and how much you need.